Admin pouch with paracord PALs and rigid inner flaps

We learn from failures more, than from successes. Recently I made an “admin” or possibles pouch, which supposed to be brilliant, but ended ahem barely capable.

My initial idea was to construct a narrow and thin pouch, fitting the upper staps on front of plate carrier, or any confined surface.

Awful confusion

Just on that week i see (here at Loaded Pockets review), that my concept Beaver tail / transporter tail – back pack upgrade already exists and marketed by Mystery Ranch as “Stick-It” and by OV Innovations as Cache (review). I can’t believe it.

So, here’s the lesson – be aware of market innovations and do not live under the rock.

P.S. New job, too little time to sew, post and even read.

Beaver tail / transporter tail – back pack upgrade

It’s very easy to add transport flap to pack – just sew two attachment points on the bottom and clip the flap. But there is a method to make it without modding pack. A special flap is needed though. And pack with PALs on lower front. And some patience.