Had a boatload of things to take care of. Showing some beta-version.
Widely known pack inserts, or organisational boards, have variuous features, so I want to make one to be suited to my specific needs.
I want to have a possibilities:
- hold A4 papers in the flat pocket
- attach modular pouches to the front PALs
- put rigid insert
- (later) have a compatibility with Tom Bihn “Rails” system, Matroskya and TAD attachments
Here is a prototype made from (s)crap materials, as clothing fabrics. So, it has terrible sagging on the top of open pocket due to the weight of pouch with thermos.
My plan is to make V-shaped entrance to flat pocket in the next prototype, so pocket wouldn’t sag.
Sorry for long lack of posts, I’m still here and even reading the blogroll.
I’ve seen at least two commercial solutions which put velcro surface over the PALs surface. Can’t believe it could happen.
To make a single-cell wide three inches height velcro attachment point we need:
- strip of loop velcro 6 (six) inches long and 1 (one) inch wide;
- strip of hook velcro 3 (three) inches long and 1 (one) inch wide;
- strip of paper about 4 inches long and about 1.25 inches wide.
Slip a hook strip under the PALs, slip a piece of paper over it, put a loop strip over the PALs and slip its ends under the PALs over the paper. Pull out the paper. Ha! Kiss your PALs goodbye, you’ll never get them back again, velcro will stay forever on them. Though, narrow knife or ruler can help, but it is questionably.
I’ve seen many examples of wrapping the cord around zipper pulls to make them silent – but it will be really silent, if wrapped from both sides of puller.
The only restraint – cord must be thin enough to come through the hole three times. So 550 cord is inappropriate.
Make every pouch 4 (four) PALs wide a Matroskya pouch! Just make a simple adapter and install it on soft clip:
Personal armor today become a subject of an intense hype. Speaking about coverage, let’s keep in mind mobility. Especially, pelvic area is a challenge to designer. Continue reading
Concept picture in previous post seemed unclear, so I made a paper model of one-piece soft PALs clip.
As you can see, PALs configuration on the pouch (two-space-one-space-two) is rare to meet, but the idea easily suits the widely known config – two-space-two.
It (five inches long) is compatible with specific PALs setup on the pouch – two-space-two, commonly found on Maxped pouches and some other manufacturers. See illustration:
Though, the longer version (7 inches) will be compatible with another PALs stup on the pouch, never found on any pouch: two-space-one-space-two. I’ll make some for testing purposes in future.